Loading... Please wait...

Our Newsletter

Straight microphone - TEN-TEC 8-Pin

3.00 LBS
Calculated at checkout

Model 709A is an omni-directional dynamic microphones designed for use as a communications station microphone for Amateur Radio and other transmitting applications. The unit consists of a die-cast zinc shell with molded sliding PTT on/off switch, dynamic microphone element and detachable multi-wire connection cable. The element has tailored frequency response from 30 Hz to 12 kHz designed for excellent transmit audio in SSB, AM, and FM modes.

Order a 710A 8-Pin Male to 4-Pin Female TEN-TEC Adaptor under Cables/Adapters for use with Jupiter Transceiver.

Pictured with optional 711 Tri-Pod table stand

Find Similar Products by Category

Write your own product review

Product Reviews

  1. Works Great

    Posted by Unknown on 14th Jan 2015

    Nice quality mic and received good audio reports from it with my TT Eagle. Also comes with a nice long cord. A nice stand with a PTT switch would be a plus though.

  2. Great modulation and sound.

    Posted by Unknown on 29th Dec 2014

    Works great with my Eagle and my Yaesu rigs. Also great value.

  3. no stand

    Posted by Unknown on 18th Nov 2013

    this is a really nice mic for the money but it doesn't come with a stand although the catalog picture show a mic stand so I was disappointed. Either make it clear there is no mic stand and change the picture or send me the stand that is pictured

  4. Great sounding audio

    Posted by Bob, K4TAX on 22nd Dec 2012

    I started using this mike with my Omni VII and immediately received "great audio" reports. I work very close { ~1"} to the mike face and "on axis". It is mounted on a desk boom for easy use and easy to push out of the way when not being used. The slide PTT switch on the side is quiet and does not add any noise or clicks when operated. I find this is a unidirectional mike an not omni directional as listed in the literature. That means any noise from the back side, being amp fans, computer or such is not being picked up and transmitted with the audio. The TX EQ is set to 0 dB with a TX BW of 2600 Hz and a TX Roll Off at 100 Hz. I normally run the Speech Processor at 40%.

    Later I purchased a 2nd 709A to use with the 599 Eagle. Again, "great audio" reports. With this radio I run the Speech Processor at #4.

    The mike provides plenty of punch with a well rounded voice sound.

  5. Great mic for TT and others.

    Posted by W5KG on 26th Jul 2012

    I have had the 709A for about 3 years now. Great reports on TT Jupiter and Yeasu rigs.
    I had a $180 mic and switched back and forth to the 709A. Other stations cound not tell the difference. Sold the $180.

  6. Good Results

    Posted by Jim on 28th Dec 2011

    I am a new ham, this is my first table top mike, I have had no problems with this equipment. It was included with the Eagle I purchased. My voice sounds like me, and I receive good signal reports using this. I do set the speech setting at "9" and the mic setting at 73